What does this calculator do?
A subnet mask and a CIDR prefix say exactly the same thing in two notations: how many leading bits of the address belong to the network. This converter moves between them and also shows the binary mask, the wildcard mask, the host-bit count and the total addresses in the block. The conversion is exact — no rounding is involved. A valid mask is a single unbroken run of 1-bits followed by 0-bits, so a value such as 255.0.255.0 is rejected with a specific message rather than converted into a meaningless prefix. Everything is computed in your browser from the values you type. Nothing is looked up on the network — there is no ping, no DNS query, no WHOIS and no geolocation.
Formula
The prefix is simply the number of leading 1-bits in the mask.
prefix = count of leading 1-bits in the mask mask = 32 bits: prefix ones, then (32 − prefix) zeros hostBits = 32 − prefix totalAddresses = 2^hostBits
How to use it
Choose whether you are starting from a prefix or from a dotted-decimal mask; the form shows only the matching input. Masks must be written in full dotted-decimal form, for example 255.255.255.192, and must contain contiguous 1-bits. The result panel shows both notations side by side plus the binary mask, which makes the bit boundary easy to see.
Worked example
Mask 255.255.255.192 converts to /26: the binary mask is 11111111.11111111.11111111.11000000, which is 26 leading 1-bits. Host bits = 6, so the block holds 2⁶ = 64 addresses, and the wildcard mask is 0.0.0.63.
Frequently asked questions
Why is 255.0.255.0 rejected?
A subnet mask must be a contiguous run of 1-bits followed by 0-bits. 255.0.255.0 turns the 1-bits back on after a gap, so it has no equivalent CIDR prefix and no router will accept it as a mask.
What does the binary mask show me?
It shows exactly where the network/host boundary falls inside the octets. For /26 the boundary is two bits into the fourth octet, which is why the blocks step by 64.
Are 255.255.255.255 and /32 valid?
Yes. /32 is a single host address, commonly used for loopback interfaces, host routes and firewall rules that match exactly one address.
Sources
- RFC 4632 — Classless Inter-Domain Routing (CIDR): the address-block, prefix-length and aggregation model used for every IPv4 subnet result on this page.
- RFC 3021 — Using 31-Bit Prefixes on IPv4 Point-to-Point Links: why a /31 has two usable addresses and no broadcast address, and why /32 is a single host.
- RFC 4291 — IP Version 6 Addressing Architecture: prefix and interface-identifier structure (IPv6 has no broadcast address). IPv6 output follows the canonical text form of RFC 5952.
- Reviewed: 2026-08-10
Related calculators
Last updated: 2026-08-10 · v1.0.0 · Report an error