What does this calculator do?
Every circle measurement determines all the others. Tell the calculator which one you know — radius, diameter, circumference or area — and it recovers the radius first, then derives the remaining three. π is used at full floating-point precision internally; only the displayed values are rounded. Use any length unit — as long as every input uses the same one, the results come out in that unit (areas in that unit squared).
Formula
Everything flows from the radius:
d = 2r C = 2πr A = πr² r = C ÷ 2π = √(A ÷ π)
How to use it
Pick the measurement you know in the selector, type its value, and read the other three from the result panel. Note the direction: if you enter the area, its value is in squared units while the radius, diameter and circumference come out in plain length units.
Worked example
Radius 5: diameter = 10, circumference = 2π×5 = 31.4159, area = π×25 = 78.5398. Entering area 78.5398 instead recovers r = 5.
Frequently asked questions
Radius or diameter — which should I enter?
Whichever you actually measured; the selector makes the distinction explicit. Mixing them up is the most common circle mistake, since d = 2r changes every downstream value by a factor of 2 or 4.
How many digits of π are used?
Full double-precision π (about 16 significant digits) in every internal step. Rounding to 4 decimals happens only at display time, so derived values do not accumulate rounding error.
Can I get the area in a different unit?
Results come out in the unit you entered (squared for the area). To switch systems — say m² to ft² — run the result through the Area Converter linked below.
Sources
- Standard circle geometry (circumference, area, arc length and sector area from the central angle). π is used at full floating-point precision internally; results are rounded only for display.
- OpenStax — Precalculus 2e (angles, radian measure, arc length and sector area)
- Khan Academy — Circles (arc length and sector area, accessible explainer)
- Reviewed: 2026-07-31
Related calculators
Last updated: 2026-07-31 · v1.0.0 · Report an error